Pricing:

Setup and Calibration Fee:...............$75 (flat fee)

This includes positioning the car on the dyno; securing the car with high-strength straps/chains; connecting our high-volume exhaust system; installing and calibrating RPM pickuo; installing any other data pickups such as O2 sensor; boost/vacuum meter; OBDII scanner; entering vehicle data and performing a coast-down calibration. Set up time is affected by the number of sensors you need for your analysis, the type of ignition, etc. and usually takes 20 - 40 minutes. This fee is payable regardless if any runs are performed.

Dyno Time:

• $120 per hour for 1st 2 hours
• $80/hr for additional hours
• HST is extra
• Cash or company cheque

Once you’re set up we’ll make as many runs as you want in your time slot. Time is counted from the time the setup is complete and includes any time you may need to make adjustments between runs.

Tuning Rate...............$80/hr
We can provide tuning on most systems. We can use your laptop or we  will arrange to load the appropriate software on our computer (we have several programs ready to go).

(As always, pricing and discounts are subject to change without notice)